We make long-range patio heaters for engineers who want heat they can count on—predictable output, simple install, and zero drama in open-air spaces. At the heart of it is a high-intensity halogen lamp, built to throw infrared warmth across distance without wasting energy heating the air around it. Here’s the thing: these heaters are built for real work. They run on 230V or 400V to match what your site already has, and the wattage is chosen to hit the heat density you need—usually between 2000W and 2500W. That gives you a beam that reaches 6–8 meters and actually delivers a measurable temperature rise. The tube length is matched to the reflector, so a 300mm tube, for example, works with a focused reflector to tighten the beam angle and push the heat farther. We use a quartz tube with halogen fill gas to keep the filament steady at high temps, so you get consistent output for thousands of hours. The tube is coated to cut down on UV and protect nearby fixtures. For wiring, we go with an R7s connector—compact, tough, and made for high heat. It plugs straight into our housing, so swapping a lamp on the shop floor is quick and painless. Outdoors, this isn’t about warming an entire room. It’s about nailing spot coverage. The halogen system kicks on instantly, sending infrared heat that cuts right through the wind, so people feel warmth where they need it—right on them. Now, it’s concentrated heat, so you’ll want to plan your mounting spot with enough clearance and make sure your electrical circuit can handle the full load. Set it up right, and you get outdoor heating that’s reliable, repeatable, and doesn’t ask for much attention.